Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hi,
I'm trying to control an ethercat driver by BBB.
I'm using the MC_Power block of SM3_Basic library 4.0.0.0
The block sets the .0 .1 .2 bit of the control word to true.
The driver i'm using (phase TW03) requires also the .3 bit to enable operation mode.
Do I need another block to set this bit? Otherwise can i modify the library?
Thanks
Best Regards
Straccio80
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi,
this is not possible, (this is not really DS402 standard if this need to be set )
The only possible paramter on generic DS402 are there is the attached screenshot.
But this does not help in your case.
BR
Edwin
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi,
I'm trying to control an ethercat driver by BBB.
I'm using the MC_Power block of SM3_Basic library 4.0.0.0
The block sets the .0 .1 .2 bit of the control word to true.
The driver i'm using (phase TW03) requires also the .3 bit to enable operation mode.
Do I need another block to set this bit? Otherwise can i modify the library?
Thanks
Best Regards
Straccio80
Hi,
you are using DS402 generic driver for using this drive?
BR
Edwin
Hi,
Thank you Edwin for your replay.
I'm using DSP402 generic drive.
What Can you suggest ?
Thanks
BR
Straccio80
Hi,
this is not possible, (this is not really DS402 standard if this need to be set )
The only possible paramter on generic DS402 are there is the attached screenshot.
But this does not help in your case.
BR
Edwin