Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hi,
I am trying to install CoDeSys on Sancloud BeagleBone Black Enhanced(Industrial Version). I am not able to Update the BBB. Image attached.
Can anyone please help me.
Regards,
Kumar
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
kumareasu hat geschrieben:
I have checked and feedback is as follows.....
1. BBB enhanced was not able sense through CoDeSys.
2. Taken Debian image from beaglebone website and booted from SD card.
3. CoDeSys is working but only through Boot through SD card.
I hope the Sancloud is not getting flashed properly.
Anyone have experience ?
Regards,
Kumar
Hi Kumar,
you need to edit /boot/uEnv.txt to trigger writing on eMMC. Just follow the tuts on elinux.org as shown for BBB.
Greetz
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi,
I am trying to install CoDeSys on Sancloud BeagleBone Black Enhanced(Industrial Version). I am not able to Update the BBB. Image attached.
Can anyone please help me.
Regards,
Kumar
Hi,
just write manually the ip - not scan - and try then if the installation process works and the runtime - starts.
BR
Edwin
I have checked and feedback is as follows.....
I hope the Sancloud is not getting flashed properly.
Anyone have experience ?
Regards,
Kumar
Hi Kumar,
you need to edit /boot/uEnv.txt to trigger writing on eMMC. Just follow the tuts on elinux.org as shown for BBB.
Greetz