Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

SanCloud Industrial

kumareasu
2019-11-05
2020-01-30
  • kumareasu - 2019-11-05

    Hi,
    I am trying to install CoDeSys on Sancloud BeagleBone Black Enhanced(Industrial Version). I am not able to Update the BBB. Image attached.
    Can anyone please help me.
    Regards,
    Kumar

    IMG: BBE.png

     
  • eschwellinger

    eschwellinger - 2019-11-25

    Hi,

    just write manually the ip - not scan - and try then if the installation process works and the runtime - starts.

    BR
    Edwin

     
  • kumareasu - 2019-12-26

    I have checked and feedback is as follows.....

    1. BBB enhanced was not able sense through CoDeSys.
    2. Taken Debian image from beaglebone website and booted from SD card.
    3. CoDeSys is working but only through Boot through SD card.

    I hope the Sancloud is not getting flashed properly.

    Anyone have experience ?
    Regards,

    Kumar

     
  • pinf - 2020-01-30

    kumareasu hat geschrieben:
    I have checked and feedback is as follows.....
    1. BBB enhanced was not able sense through CoDeSys.
    2. Taken Debian image from beaglebone website and booted from SD card.
    3. CoDeSys is working but only through Boot through SD card.
    I hope the Sancloud is not getting flashed properly.
    Anyone have experience ?
    Regards,
    Kumar

    Hi Kumar,

    you need to edit /boot/uEnv.txt to trigger writing on eMMC. Just follow the tuts on elinux.org as shown for BBB.

    Greetz

     

Log in to post a comment.