Presently working with BeagleBoneBlack, trying with BBB with EK1100+EL2809+EL6080.
Could you please clarify the following....
1. My application is not getting started when power on the BBB.(Still I have not Activated lenience)
2. I am not able to map EL6080 for retentive variables.
3. Do we need to have proper shutdown of BBB or we can plug out the power(5V). Any feedback Data Corruption.
Regards,
Kumar Eswaran
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi,
Presently working with BeagleBoneBlack, trying with BBB with EK1100+EL2809+EL6080.
Could you please clarify the following....
1. My application is not getting started when power on the BBB.(Still I have not Activated lenience)
2. I am not able to map EL6080 for retentive variables.
3. Do we need to have proper shutdown of BBB or we can plug out the power(5V). Any feedback Data Corruption.
Regards,
Kumar Eswaran
Hi,
this should start, check the plclogger or do a cat /tmp/codesyscontrol.log to see details for the starting Problem
see attached example but no further support from my side ;-(
If not set to readonly in generell yes!
BR
Edwin
El6080.project [66.97 KiB]