Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hello,
I have a multiple application project, where master application runs PLC and child application HMI.
Codesys allows to add Alarm Configuration only on master application, but i can't point the master alarm datasource on Alarm table or Alarm banner objects located on child application HMI.
Any ideas?
Thanks for your help
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello,
I have a multiple application project, where master application runs PLC and child application HMI.
Codesys allows to add Alarm Configuration only on master application, but i can't point the master alarm datasource on Alarm table or Alarm banner objects located on child application HMI.
Any ideas?
Thanks for your help