Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

Bug in Trend/TimeSelector? [solved]

LukaszBien
2017-07-31
2022-06-27
  • LukaszBien - 2017-07-31

    I've noticed that Time Selector works not really well in the SP11..
    To see 1 hour window on trend I need to set 1000h in Time Selector.
    Is this a bug or is there something else need to be set. As far as I remember in SP10 there was a possibility to change resolution
    from s to ms in trend properties (or something like that)
    but in SP 11 I cannot find that option..
    Best Regards
    Lukasz.

     
  • LukaszBien - 2017-08-10

    Looks like I have to reply to my own question..

    It looks like there is possibility to set resoultion in the Time Range Picker element :

    But only **before ** attaching Trend element. After attaching, this option is not avaliable:

    That's why I was struggling to find it earlier

    So if your trend is showing some weird thing , set this option to microseconds and it should be fine.

    (to be honest not sure why this option even exists as when set to ms time range picker is not working correctly)

    Hope it will help someone

    IMG: Capture.PNG

    IMG: Capture1.PNG

     
  • Araforn - 2018-02-27

    LukaszBien hat geschrieben:
    Looks like I have to reply to my own question..
    It looks like there is possibility to set resoultion in the Time Range Picker element :
    Capture.PNG
    But only attaching Trend element. After attaching, this option is not avaliable:
    Capture1.PNG
    That's why I was struggling to find it earlier
    So if your trend is showing some weird thing , set this option to microseconds and it should be fine.
    (to be honest not sure why this option even exists as when set to ms time range picker is not working correctly)
    Hope it will help someone

    Just wanted to say thanks so much for this info. I was struggling with the time selector too until I read this post. Really hard to find when the option is not available after attaching.

    Thanks again.

     
  • jeremyshubert - 2021-02-09

    Thanks so much for sharing this.

     
  • snid - 2022-06-27

    Thanks a lot this problem still exists in 3.5.17

     

Log in to post a comment.