Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
i'm working with Codesys V3 and the PLC Handler configured for ARTI3. In my research, i see that the PLC Handler works only when a Symbol Configuration is loaded on target, in all other cases fails in execution/ commanding. Also if an empty Symbol Configuration is loaded to the target the result is negative.
In detail for fails, they are in relation to or always resulting error code 1. In case if configure the omit of loading Symbol Configuration on connect, all interaction with the interface results error code 5.
Is there any possibility to get it working without a Symbol Configuration on device?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello,
i'm working with Codesys V3 and the PLC Handler configured for ARTI3. In my research, i see that the PLC Handler works only when a Symbol Configuration is loaded on target, in all other cases fails in execution/ commanding. Also if an empty Symbol Configuration is loaded to the target the result is negative.
In detail for fails, they are in relation to or always resulting error code 1. In case if configure the omit of loading Symbol Configuration on connect, all interaction with the interface results error code 5.
Is there any possibility to get it working without a Symbol Configuration on device?
Hi,
no this is not possible, symbolconfiguraton is mandatory for using plchandler/opcua
BB
Edwin