CODESYS - the IEC 61131-3 automation software
https://forum.codesys.com/

Trace X-axis Cursors
https://forum.codesys.com/viewtopic.php?f=25&t=7093
Page 1 of 1

Author:  himanshu [ Tue Jul 26, 2016 10:36 am ]
Post subject:  Trace X-axis Cursors

Hello,
In trace manager, If I use two cursors then I can see Delta Y values(Y2-Y1 values) on right hand side , but I can not see deltaX (X2-X1 values).
How to configure to see Delta X values.

Regards,
Himanshu

Page 1 of 1 All times are UTC+01:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/