Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hello,
In trace manager, If I use two cursors then I can see Delta Y values(Y2-Y1 values) on right hand side , but I can not see deltaX (X2-X1 values).
How to configure to see Delta X values.
Regards,
Himanshu
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello,
In trace manager, If I use two cursors then I can see Delta Y values(Y2-Y1 values) on right hand side , but I can not see deltaX (X2-X1 values).
How to configure to see Delta X values.
Regards,
Himanshu