CODESYS - the IEC 61131-3 automation software

Welcome to the official CODESYS Forum by 3S-Smart Software Solutions GmbH | A member of the CODESYS Group
Deutsche Version English version russian version 
It is currently Sat Dec 07, 2019 5:55 am

All times are UTC+01:00




Post new topic  Reply to topic  [ 1 post ] 
Author Message
 Post subject: Trace X-axis Cursors
PostPosted: Tue Jul 26, 2016 10:36 am 
Offline

Joined: Wed Jun 22, 2016 8:28 am
Posts: 8
Hello,
In trace manager, If I use two cursors then I can see Delta Y values(Y2-Y1 values) on right hand side , but I can not see deltaX (X2-X1 values).
How to configure to see Delta X values.

Regards,
Himanshu


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 1 post ] 

All times are UTC+01:00


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited