Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I'm a teacher who wants to make the switch from a brand-dependent to a brand-independent programming language. I have chosen CoDeSys just for that. Now I downloaded CoDeSys 3.5 and tried out the simple steps as described in this 7 minute video:
E.g. defining an input and connected output and attach a bulb and switch to them. I made a build, put CoDeSys in Simulation mode and ran the program: it doesn't work No matter what I try or change, I can't get it to run. I get the error messages as displayed in the screenshot. What am I doing wrong?
It looks so easy in the video...
Thanks in advance and greetings from the Netherlands,
MJFD
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello There,
I'm a teacher who wants to make the switch from a brand-dependent to a brand-independent programming language. I have chosen CoDeSys just for that. Now I downloaded CoDeSys 3.5 and tried out the simple steps as described in this 7 minute video:
https://www.youtube.com/watch?v=2tX6gumm2zg
E.g. defining an input and connected output and attach a bulb and switch to them. I made a build, put CoDeSys in Simulation mode and ran the program: it doesn't work No matter what I try or change, I can't get it to run. I get the error messages as displayed in the screenshot. What am I doing wrong?
It looks so easy in the video...
Thanks in advance and greetings from the Netherlands,
MJFD
Check this topic: http://forum.codesys.com/viewtopic.php?f=11&t=6422