Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I have a customer that is getting a hardware watchdog timeout when setting a breakpoint using the CIFX Ethernet/IP. Is there a way to disable this behavior? this is using Control RTE on Windows.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
After reading something that was "similar" on the forum, I was able to get the customer to check the update I/O while stopped, AND, create a separate task for the I/O exchange. This allowed him to get past the watchdog issue.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I have a customer that is getting a hardware watchdog timeout when setting a breakpoint using the CIFX Ethernet/IP. Is there a way to disable this behavior? this is using Control RTE on Windows.
After reading something that was "similar" on the forum, I was able to get the customer to check the update I/O while stopped, AND, create a separate task for the I/O exchange. This allowed him to get past the watchdog issue.