CODESYS - the IEC 61131-3 automation software

Welcome to the official CODESYS Forum by 3S-Smart Software Solutions GmbH | A member of the CODESYS Group
Deutsche Version English version russian version 
It is currently Tue Aug 20, 2019 7:25 pm

All times are UTC+01:00




Post new topic  Reply to topic  [ 1 post ] 
Author Message
PostPosted: Mon Jul 22, 2019 2:54 pm 
Offline

Joined: Tue Jul 16, 2019 12:30 pm
Posts: 1
Hi all,

I am new to Codesys and Linux, and I have a question about connecting a phyboard-Mira based device (which is run on Linux) to a Codesys V3 software. I connected phyBoard-Mira to my PC via ethernet, and I am seeing the device as eth0 when I type ifconfig on my terminal. It sends some data via MQTT protocol, and I am able to get that data with a python code and it is all working, but when I try to get that data in Codesys, I am having troubles even recognizing the device. I have tried setting the eth0 IP address as a Gateway, but it won't work and Codesys delivers the scan failed message.

I have looked on the forum for solutions, and I don't know if it is necessary to have a Codesys Control package for Linux SL to do this? Also, do I need to connect my PLC first and then do this kind of communication, i.e. do I need to connect both the PLC and the phyBoard-Mira based device for this to work?

Best regards,
Petar


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 1 post ] 

All times are UTC+01:00


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited