Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hi it is my first use of codesys with canopen device
i want to connect a faulhaber motor with canOpen position driver embedded:
i set my canOpen mapping in my motor driver and in codesys
then i want to edit the I/O mapping i do not see all my AnOpen variable:
how to add mapping ?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi it is my first use of codesys with canopen device
i want to connect a faulhaber motor with canOpen position driver embedded:
i set my canOpen mapping in my motor driver and in codesys
then i want to edit the I/O mapping i do not see all my AnOpen variable:
how to add mapping ?