Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hi All,
i'm configuring a Profinet network on my PC.
I have the ethernet and the PN controller running.
The "Slave Device " remain in orange status and if I check on the PLC's log i find the error: " RPC failed 0x16c9a085".
Am I missing something in the configuration?
There is something special to check?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi All,
i'm configuring a Profinet network on my PC.
I have the ethernet and the PN controller running.
The "Slave Device " remain in orange status and if I check on the PLC's log i find the error: " RPC failed 0x16c9a085".
Am I missing something in the configuration?
There is something special to check?
Hello Matteo;
Were you able to solve your problem? I have the same case
which plc and which version especialky whicht profinet contoller version are involved?