Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I am sorry about the recurrent posts but everytime I make a step forward I face a new issue. Once I get this working I will summarize all the steps to get Codesys to run on a CX5120 so that other people can do it smoothly.
I installed CODESYS_Control_RTE_SL_for_Beckhoff_CX_3.5.13.20. The manual specifies that the Beckhoff CCAT driver has to be updated with Codesys's CmpCX5000Mpd.sys but there is no driver in nor folder named 'CmpCX5000Mpd' in installation folder
Any tips?
Thank you in advance,
Omar
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi guys,
I am sorry about the recurrent posts but everytime I make a step forward I face a new issue. Once I get this working I will summarize all the steps to get Codesys to run on a CX5120 so that other people can do it smoothly.
I installed CODESYS_Control_RTE_SL_for_Beckhoff_CX_3.5.13.20. The manual specifies that the Beckhoff CCAT driver has to be updated with Codesys's CmpCX5000Mpd.sys but there is no driver in nor folder named 'CmpCX5000Mpd' in installation folder
Any tips?
Thank you in advance,
Omar
Hi,
attached the driver.. (3.5.13.20 32Bit Version)
BR
Edwin
CmpCX5000.zip [30.78 KiB]
Hi Erwin,
You made my weekend! Thank you!
Gr, Omar