sure if you use WAGO 750-8204 and the local CAN it works... only the additional slide is not implemented.
(thought you need a second CAN port/interface)
>I just need one CAN connector to send some CAN layer 2 messages to an IFM RTC module
yes should work check the example in the CODESYS Store:https://store.codesys.com/can-bus-examp ... escription
Also a completely different question:
If I assign the service port to the runtime would I then be able to use this cable for RS-232 communication from CoDeSys 3 https://www.wago.com/us/controllers-bus
... /p/750-920 ?
and in addition use the serial port on the base of the CPU for RS-485 Modbus RTU communication?
Think this might work ( never used it that way) See screenshot
You need to change the setting in the service Interface - then figure out which com port is assigned... maybe a symbolic link is needed
/dev/ttyO is the regular interface you need to add the service interface then to /dev/ttyO +1
COM1 – (/dev/ttyO0) Onboard-Sub-D(X3)
COM2 – (/dev/ttyO2) Konfigurations- und Programmierschnittstelle
so you need to change the link /dev/ttyO1 should point to /dev/ttyO2 that in CODESYS the devices are accesible by Com1 and Com2