Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

PFC100 serialmode error

Runtime 🇬🇧
MortenL
2018-10-24
2018-10-26

  • MortenL - 2018-10-24

    Hello

    I have installed a PFC100 CoDeSys runtime on my WAGO 750-8102

    I'm trying to use the 'serialmode' command in PLC shell to set the serial port of my 750-8102 to RS-232 but it does not seem to work:

    serialmode

    unknown

    serialmode rs232

    ioctl error

    If I assign the serial port to the linux console in the WBM this is correctly identified by CoDeSys:

    serialmode

    Linux console

    However if I set it to 'unassigned' again the errors occur again:

    serialmode

    unknown

    serialmode rs232

    ioctl error

    I have tried resetting the controller, uninstalling and reinstalling the runtime, rebooting a ton of times.

    I have a PFC200 (750-8202) with a PFC200 runtime where the command works perfectly.

    Is the serialmode command not supported by the PFC100? Or do I need to do something else?

     

  • eschwellinger

    eschwellinger - 2018-10-26

    Hi,
    sounds like a bug,
    could you report to the CODESYS store -> my question bug report?
    BR
    Edwin

     

Log in to post a comment.