Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hello,
I am using Control Win V3 for an application that is using a PEAK PCAN USB to connect to the CANbus. I can see messages on the bus and if I transmit a message using PCAN-view I can see it in my application but I am unable to see my own messages that are being sent out through the CoDeSys application. Any thoughts on why this might be happening?
Thanks,
CB
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello,
I am using Control Win V3 for an application that is using a PEAK PCAN USB to connect to the CANbus. I can see messages on the bus and if I transmit a message using PCAN-view I can see it in my application but I am unable to see my own messages that are being sent out through the CoDeSys application. Any thoughts on why this might be happening?
Thanks,
CB