Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

Upboard+Windows IoT + Codesys RTE

kumareasu
2017-10-25
2017-12-04
  • kumareasu - 2017-10-25

    Hi,
    I am trying to integrate UPBoard( w www.up-board.org w ) installed with Windows IoT Enterprises +Codesys RTE.
    PLC is not starting.
    Please share your experience.
    Regards,
    Kumar.E

     
  • eschwellinger

    eschwellinger - 2017-10-25

    Hi,
    never tried (have no board available to test it)
    you need to check:
    1. Does it have bios settings like ipc's if yes:
    disable speedstep c-states etc all Features which have influence on the cpu core speed ( RTE need a stable CPU core clock speed to be hard realtime capable)
    2. on 64bit - to deactivate hyperthreading is mandatory

    BR
    Edwin

     
  • kumareasu - 2017-11-30

    Edwin,
    i am not sure, I assume as follows...
    while we disable the hyperthreading, the processor will work as singe core. using the quad core motherboard is as googd as using single core
    Please confirm..
    Kumar.E

     
  • eschwellinger

    eschwellinger - 2017-11-30

    Hi,
    which processor is build in in this board (they offer several boards I could not really see which is yours)
    BR
    Edwin

     
  • kumareasu - 2017-12-04

    Edwin,

    Processor used in this board ..

    Intel® Celeron™ N3350 (up to 2.4 GHz)
    Intel® Pentium™ N4200 (up to 2.5 GHz)
    Intel® Atom ™ E3940 (up to 1.8Ghz )

    LAN ..
    2x Gb Ethernet (full speed, Realtek 8111G) RJ-45

     
  • eschwellinger

    eschwellinger - 2017-12-04

    Hi,
    from my point of view this should work on all these 3 boards.
    How could we check them?
    Could we get hardware or by remote session?

    BR
    Edwin

     

Log in to post a comment.