Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

PFC200 CANbus Manager

2017-08-21
2017-08-23
  • raymondclark1 - 2017-08-21

    Hi,

    I have a PFC200 with the codesys V3.5 runtime installed, I am trying to add a CANopen slave to the PLC with the PLC as a master, I have added the CANbus device -> CANopen Manager -> My Device. But the CANopen Manager will not start, it always has the Orange warning triangle with status "Not Running".

    The CANbus device shows "Running" but every so often (30s or so) it will briefly change to "Bus Failure" then back to "Running". I do not see the CAN light on the PFC200 light up at all.

    Thanks,
    Raymond.

    IMG: CANopenSlave.png

     
  • eschwellinger

    eschwellinger - 2017-08-21

    Hi,
    which version are you using exactly?
    There is a bug in SP11 version... will be solved with 3.5SP11patch1.
    BR
    Edwin

     
  • raymondclark1 - 2017-08-21

    Hi Edwin,

    Yeah i'm using SP11, do you know when patch 1 will be released?

    Thanks,
    Raymond.

     
  • eschwellinger

    eschwellinger - 2017-08-23

    It is available now..
    BR
    Edwin

     

Log in to post a comment.