Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I'm looking for a very low latency communication option between raspberry pi running codesys and arduino, I know that spi is fast but i dont know how to setup spi com in codesys, anyone with experience doing so I would love some advice, my setup contains 2x teensy 3.6 slaves and 1 raspberry pi master.
I'm currently using modbus TCP to do my comunication but so far my average latency for a round trip around 10 -20 ms and as my project size increases I expect this latency also to increase, so any suggestions to get lower latency ?
Sent from my SM-N9500 using Tapatalk
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi all
I'm looking for a very low latency communication option between raspberry pi running codesys and arduino, I know that spi is fast but i dont know how to setup spi com in codesys, anyone with experience doing so I would love some advice, my setup contains 2x teensy 3.6 slaves and 1 raspberry pi master.
I'm currently using modbus TCP to do my comunication but so far my average latency for a round trip around 10 -20 ms and as my project size increases I expect this latency also to increase, so any suggestions to get lower latency ?
Sent from my SM-N9500 using Tapatalk