CODESYS - the IEC 61131-3 automation software

Welcome to the official CODESYS Forum by 3S-Smart Software Solutions GmbH | A member of the CODESYS Group
Deutsche Version English version russian version 
It is currently Sun Sep 15, 2019 9:19 am

All times are UTC+01:00




Post new topic  Reply to topic  [ 1 post ] 
Author Message
PostPosted: Tue Apr 23, 2019 1:33 am 
Offline

Joined: Tue Apr 16, 2019 5:12 pm
Posts: 5
Hi, I'm trying to run a stepper motor with an MA860 driver.
I tried to make it work from codesys, giving pulses, codesys does not allow me to drive the engine very fast or use all the speed of my raspberry pi (GPIO 17 PWM). Then I decided to create a scrip based on this viewtopic.php?f=23&t=6247&p=19932#p19941
When I charge it it works without any error. but it does not do anything.
Does anyone have any idea how to run the scrip? I've seen it all over the forum but I have not found the problem.

I attached my program in addition to my scrip


You do not have the required permissions to view the files attached to this post.


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 1 post ] 

All times are UTC+01:00


Who is online

Users browsing this forum: No registered users and 5 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited