Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

Can't connect

2019-01-28
2019-01-29
  • urbanlarsson - 2019-01-28

    Hi!

    I have reconnected my old Raspberry with Codesys, updated Codesys to 3.4.15 and also updated the Pi to 3.5.14.

    But now i can't connect, Codesys won't see my Pi, please advice.

    I can read system info and start/stop but not login and scan network doesnΓ€t find anything.

    /U

     
  • eschwellinger

    eschwellinger - 2019-01-28

    Hi,
    add the Pi IPAdress as Gateway address and scan via this Gateway ( Gateway embedded in the PI)

    BR
    Edwin

    IMG: addgatewayIPAddr.png

    IMG: gateway2.png

     
  • urbanlarsson - 2019-01-28

    Edwin,

    then I get "Please check that the gatweay is running"

     
  • eschwellinger

    eschwellinger - 2019-01-28

    Hi,
    you need to check if the runtime is up and running:
    1. by ssh with the following command:
    top

    1. you could do the same by the updatetool by executing systeminfo.
      see screenshot

    BR
    Edwin

    IMG: UpdateToolSysinfo.png

     
  • urbanlarsson - 2019-01-28

    I'm connected and the runtime is started, right?
    But I still can't scan the gateway

    /U

    IMG: pi.jpg

     
  • eschwellinger

    eschwellinger - 2019-01-28

    Hi,
    you need to disable 'preticable network names' by
    sudo raspi-config
    this will solve it I'm pretty sure.

    BR
    Edwin

     
  • urbanlarsson - 2019-01-29

    It's disabled but I still can't scan network

     

Log in to post a comment.