Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I'm trying to interface a 3Wire timekeeper chip (DS1302) with Codesys. I'm actually stuck on the SPI interface since this chip is a 3Wire chip. i.e. MISO and MOSI are shared on one single pin. Is it possible to set the SPI_mode to 3Wire? It is using spiDev ... Is it in Codesys
Thanks,
Koen.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi all,
I'm trying to interface a 3Wire timekeeper chip (DS1302) with Codesys. I'm actually stuck on the SPI interface since this chip is a 3Wire chip. i.e. MISO and MOSI are shared on one single pin. Is it possible to set the SPI_mode to 3Wire? It is using spiDev ... Is it in Codesys
Thanks,
Koen.