Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hi guys, I'm trying to connect raspberry pi 2 with Matrox camera over Profinet. I've read and followed some old topic in our forum and here i got (see the picture below). Anyone know what i did i do wrong?
Thanks!
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi guys, I'm trying to connect raspberry pi 2 with Matrox camera over Profinet. I've read and followed some old topic in our forum and here i got (see the picture below). Anyone know what i did i do wrong?
Thanks!
After few second it run in 0.5s then back to disable again.
Hi,
you need to adjust sendclock and reduction ratio...
BR
Edwin
Hi Ed, seem like i can't adjust send clock? Do you know what happen?
I can change the ratio btw.
Hi,
is Ethercat and Profinet on the same network interface?
BR
Edwin
Yes Ed, is it wrong?
But before i connect ethercat the problem still there.