I am trying use raspberry pi3 +b board. I make codesys test program. Program send to raspberry board run system running. I connected Led cathode to PIN 6 (GND) and led anode to PIN12 (PGIO18). Then I set PGIO18 TRUE level, but led doesn't shine. I don't know where are my mistake. Maybe could give me advice, how solve this problem. I think problem is with raspberry, but I write python program
import RPi.GPIO as GPIO
for x in range(0,10):
Led is blinking.
GPIOs IEC parameters:
I attached all my test project.
when program is onlinehttps://www.part.lt/img/5a95e7c981c8345 ... ba8627.jpg