Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I want to use Raspberry Pi + Codesys as a Chemistry Controller for my pool. The Idea is to measure PH and REDOX Potential with Electrodes and control Pumps for injection of necessary chemistry.
I found following RPI modules, which are suitable for measurements: EZO ORP, EZO PH from Atlas Scientific and Tentacle T3 to host those on RPi. The boards have I2C Interface and supplied with source code on Python.
How do you think would it be possible to make the readings via Codesys? Or perhaps someone did driver already? Or is there any other alternative measurement modules available?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello,
I want to use Raspberry Pi + Codesys as a Chemistry Controller for my pool. The Idea is to measure PH and REDOX Potential with Electrodes and control Pumps for injection of necessary chemistry.
I found following RPI modules, which are suitable for measurements:
EZO ORP, EZO PH from Atlas Scientific and Tentacle T3 to host those on RPi. The boards have I2C Interface and supplied with source code on Python.
How do you think would it be possible to make the readings via Codesys? Or perhaps someone did driver already? Or is there any other alternative measurement modules available?