Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hi,
I'm evaluating the opportunity to interconnect some S7-300 Profinet periphery with a Raspberry PI 3 PLC in CODESYS.
On board, the S7-300 remote devices are equipped with some digital and analogue input and output boards.
Is it possible to use this periphery with Raspberry? Could someone drive me?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi,
yes this is possible Pyou could use Profinet Controller or Profinet device on the Pi side.
See the example in the Raspberry PI libs and examples section in this forum.
BR
Edwin
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi,
I'm evaluating the opportunity to interconnect some S7-300 Profinet periphery with a Raspberry PI 3 PLC in CODESYS.
On board, the S7-300 remote devices are equipped with some digital and analogue input and output boards.
Is it possible to use this periphery with Raspberry? Could someone drive me?
Hi,
yes this is possible Pyou could use Profinet Controller or Profinet device on the Pi side.
See the example in the Raspberry PI libs and examples section in this forum.
BR
Edwin