Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Is there any way that any modification of variables that is made in an entire Program is recorded by the user?
I have achieved this by entering all the variables in a group of alarms and selecting the type of supervision by modification, but it forces me to enter all the parameters of the plc 1 to 1.
There is no easier way to do it.
Best Regards,
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello:
Is there any way that any modification of variables that is made in an entire Program is recorded by the user?
I have achieved this by entering all the variables in a group of alarms and selecting the type of supervision by modification, but it forces me to enter all the parameters of the plc 1 to 1.
There is no easier way to do it.
Best Regards,