Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
hi, I think there is an error for the type ,to be confirmed, because I'm not sure :
"Set the Type to 502 for all I2C devices
<devicedescription>
...
<device>
...
<deviceidentification>
...
<type> 502 </type>
...
</deviceidentification>
...
</device>
...
</devicedescription> "
in the xml file the type is 501, as for the SPI devices.
thanks
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello fellow Raspberry enthusiast!
Here is a device library for the MCP4728 4-Channel 12-bit DAC, default address = 0x60.
Input an integer 0-4095 for each channel.
MCP4728.devdesc.xml [2.38 KiB]
I2C_MCP4728.library [335.03 KiB]
Hi, can you tell me how you wiring the mcp4728 to the pi???
im confused about the ldac and the rdy/bsy pin.
regards Matthias
hi, I think there is an error for the type ,to be confirmed, because I'm not sure :
"Set the Type to 502 for all I2C devices
<devicedescription>
...
<device>
...
<deviceidentification>
...
<type> 502 </type>
...
</deviceidentification>
...
</device>
...
</devicedescription> "
in the xml file the type is 501, as for the SPI devices.
thanks