Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I want to use the adafruit 16 channel servo control and use motors that have positional feedback. My application will involve gearing in of axis to each other. Will this need additional license on the software, runtime, both?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Thanks for the reply. That is good news. The servo motors I plan to use have analog feedback. I cannot use that directly with the servo driver, but there should be some way to integrate within the software?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I want to use the adafruit 16 channel servo control and use motors that have positional feedback. My application will involve gearing in of axis to each other. Will this need additional license on the software, runtime, both?
Hi,
no additional license needed, but how to get the position feedback?
BR
Edwin
Thanks for the reply. That is good news. The servo motors I plan to use have analog feedback. I cannot use that directly with the servo driver, but there should be some way to integrate within the software?