Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
BenGor hat geschrieben:
Hey there,
I am trying to configure my Raspi as a Ethernet Adapter. Following the instruction from https://forum.codesys.com/viewtopic.php?t=7237, i managed to extract a eds file etc. My Problem is that I can't get it started. Codesys always tells me that the bus is not running. I set Main Task as my task in the Ethernet adapter. But any other setting won'twork either. Hope anyone could help me? Thank!
Error.png
I don't mean to hijack your thread but im having some trouble with Ethernet/IP as well.
l viewtopic.php?f=21&t=8897 l
What does it say when you view "status"?
In my case the bus will run fine when there's no I/O configured. When I add it manually with the information I get from the EDS it won't work.
The eds file opens fine in different programmers.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hey there,
https://forum.codesys.com/viewtopic.php?t=7237
I don't mean to hijack your thread but im having some trouble with Ethernet/IP as well.
l viewtopic.php?f=21&t=8897 l
What does it say when you view "status"?
In my case the bus will run fine when there's no I/O configured. When I add it manually with the information I get from the EDS it won't work.
The eds file opens fine in different programmers.
It says "Not Running"