Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Good morning, I would like to use a SCT013-30 to read a consumption.
Practically for arduino there is everything on the net but I would like to use it on the raspberry on which runs codesys.
Theoretically / practically I should connect it to an analogue raspberry input, read the value and transform the value into codesys.
This is the method?
Thanks, Alberto
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Good morning, I would like to use a SCT013-30 to read a consumption.
Practically for arduino there is everything on the net but I would like to use it on the raspberry on which runs codesys.
Theoretically / practically I should connect it to an analogue raspberry input, read the value and transform the value into codesys.
This is the method?
Thanks, Alberto