Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Good evening,
I have a small program that manages two shutters with closing and opening programmed daily.
I used 4 OSCAT_BUILDING.Timer2
Now I would like to test its operation in simulated mode but I have problems.
The four oscat modules are identical and differ only in duration of operation and start time.
If I try to change the start time at runtime two of them work and the other two do not.
If I send the code on the raspberry that manages the shutters everything works regularly !!
Why ?
So I tried to make a new project by inserting only an OSCAT_BUILDING.TIMER2 and setting the start at runtime, however, I do not see the output .Q of the timer go to true !!
How can I check the operation of this timer in simulation mode?
Thanks, Alberto
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Good evening,
I have a small program that manages two shutters with closing and opening programmed daily.
I used 4 OSCAT_BUILDING.Timer2
Now I would like to test its operation in simulated mode but I have problems.
The four oscat modules are identical and differ only in duration of operation and start time.
If I try to change the start time at runtime two of them work and the other two do not.
If I send the code on the raspberry that manages the shutters everything works regularly !!
Why ?
So I tried to make a new project by inserting only an OSCAT_BUILDING.TIMER2 and setting the start at runtime, however, I do not see the output .Q of the timer go to true !!
How can I check the operation of this timer in simulation mode?
Thanks, Alberto
Hello,
without the code or code snipped not easy to help.
Best Regards
plcmax