Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

no connection to target (Raspberry not found)

Runtime 🇬🇧
massaproduxy
2018-04-24
2018-04-26

  • massaproduxy - 2018-04-24

    Hi everyone,
    With Linux/Jessie on the Raspberry, I can without problem "scan network" and "connect" the Pi to Codesys...
    But I'm trying now a new kernel 4.4.9-rt17-v7 (patch Preempt_rt) and I face difficulties.

    Via wifi the Pi is well connected to the router (I've got a IP and internet) and
    with I got the right of the Pi's connection:

    I can even reboot the Pi with ""
    but I can't connect the Raspberry to Codesys !

    Do someone knows why ? What has changed with the new kernel ?
    Thank you in advance.

    IMG: System infos RPi.JPG

     

  • eschwellinger

    eschwellinger - 2018-04-25

    Hi,
    could you give us results of (Login by ssh / putty)

    cat /tmp/codesyscontrol.log

    or try:
    sudo /etc/init.d/codesyscontrol stopsudo /etc/init.d/codesyscontrol start

    BR
    Edwin

     

  • massaproduxy - 2018-04-26

    Thanks Edwin,

    I did and sudo replied: unknown command

    runtime was obviously not correctly installed. Now it's fixed and I'll try to get the servo in motion ...

    Best Regards

     

Log in to post a comment.