Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

How do you deal with this situation now?

Runtime 🇬🇧
kakawa
2018-03-25
2018-03-25

  • kakawa - 2018-03-25

    Hello. I need to troubleshoot ethercat.
    I have found that RT-Preempt is not installed when I search the forum. Is that right?
    I could not find a solution to this problem, so I searched for the material and found this homepage. Does it matter if I run it like this?
    https://github.com/koppi/mk/blob/master ... mpt-RPI.md
    I'll wait for the good news.

    IMG: d2.png

    IMG: d1.png

     

  • eschwellinger

    eschwellinger - 2018-03-25

    Hi,
    please connect your ethercat slaves to eth0 1:1 connection - not wlan,wifi for the CODESYS connection.

    BR
    Edwin

     

  • kakawa - 2018-03-25

    Status when connecting to Ethernet.

    IMG: d4.png

    IMG: d3.png

     

  • kakawa - 2018-03-25

    Thank you. Success after retrying.
    It was a problem with KL2184.
    This is because I can not find the XML or MDP file of this module and can not register it
    I can not find the file in this file on beckhoff. If not, where should I find the material in this file?
    Thanks again. This problem hurt my head for a week.

    IMG: d5.png

     

  • eschwellinger

    eschwellinger - 2018-03-25

    Hi,
    yes could confirm, if you have an chance to use ELxxxx and EKxxxx
    instead of Kbus - I would do it.

    BR
    Edwin

     

Log in to post a comment.