Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hi,
I have done two different projects, one with MCP23017 board (i2C) and the second with DS18B20 temperature sensor. For each project the Raspberry works well, but when I put both projects in one, the cycle time goes to 8 second instead of 10ms that I reach with the separate projects.
Could someone help me?
Thanks in advance
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi,
I have done two different projects, one with MCP23017 board (i2C) and the second with DS18B20 temperature sensor. For each project the Raspberry works well, but when I put both projects in one, the cycle time goes to 8 second instead of 10ms that I reach with the separate projects.
Could someone help me?
Thanks in advance
Hi,
this example project from the application section (in this Forum) should point you in the right direction:
l viewtopic.php?f=23&t=6247&p=16920#p16920 l
BR
Edwin