Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I have a stepper motor drive with 1/16 resolution. For done 1 turn I need to generate 3200 pulses.
If I put 3200 value in "increments" or a value greater than 1, the EL2521 don´t generate pulses
to correctly. What is the correct configuration?
Now when I move in absolute, to do one turn I have to put 3200 value. In "units" don´t let me put a
float value.
thanks, regards,
Ivan
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Good morning,
I have a stepper motor drive with 1/16 resolution. For done 1 turn I need to generate 3200 pulses.
If I put 3200 value in "increments" or a value greater than 1, the EL2521 don´t generate pulses
to correctly. What is the correct configuration?
Now when I move in absolute, to do one turn I have to put 3200 value. In "units" don´t let me put a
float value.
thanks, regards,
Ivan