Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hi,
It is posible by using Softmotion and related configuration from my screenshot. Just use then the MC_Move... fb's to control the position.
BR
Edwin
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Good morning,
I get control of speed on a stepper motor but I canΒ΄t control the position.
How can I adjust EL2521 parameters to travel 1mm with 200 pulse to stepper motor?
Thanks, regards
Iban
Hi
Did you make it run 1mm as you mention? If yes please share
Good mornong,
you need position feedback. I use EL5101 to read the
encoder on my stepoer
Hi,
no this works that way without encoder...
BR
Edwin
Hello Edwin,
without encoder I canΒ΄t control de position. Only control the speed.
thanks
Hi,
It is posible by using Softmotion and related configuration from my screenshot. Just use then the MC_Move... fb's to control the position.
BR
Edwin