Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I'm a newbie and I discover Codesys with my Raspberry Pi3.
I know that on the Siemens PLC and Tia Portal (for exemple S7-1200) an output is like Q1.1 (the CPU executes the user program and at the end, write the output process image to the physical outputs).
By appending a ":P" for exemple Q1.1:P the program write immediately to the physical output.
Is there something similar with the RPI in Codesys ?
Thank you
Philipp
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi,
I'm a newbie and I discover Codesys with my Raspberry Pi3.
I know that on the Siemens PLC and Tia Portal (for exemple S7-1200) an output is like Q1.1 (the CPU executes the user program and at the end, write the output process image to the physical outputs).
By appending a ":P" for exemple Q1.1:P the program write immediately to the physical output.
Is there something similar with the RPI in Codesys ?
Thank you
Philipp