Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Good morning,
use codesys with a raspberry card that controls two plc controllino.
Now I wanted to be able to control the heat pump with an infrared led with another raspberry card placed in the house.
Choosing the settings is in codesys but how can i send it to the raspberry card?
That is, what method of communication should I use and then how do I send the command?
Give me a line to follow?
Thank you, Alberto
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Good morning,
use codesys with a raspberry card that controls two plc controllino.
Now I wanted to be able to control the heat pump with an infrared led with another raspberry card placed in the house.
Choosing the settings is in codesys but how can i send it to the raspberry card?
That is, what method of communication should I use and then how do I send the command?
Give me a line to follow?
Thank you, Alberto