Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Good morning,
in my apartment I do not have the ability to pull other cables to match some equipment.
The only connection I have between the apartment and the control point where I have raspberry with codesys is the network.
My aim is to send the status of a button to codesys and how many times it is pressed to run preset scenarios.
For example, press the button once, turn on all the lights, press twice, turn off all the lights, press the button for a long time, cancel the operation.
In large lines is what I would like to do
So I was thinking of installing an arduino and passing the states via modbus directly to codesys?
Is it possible for you to do this in this way?
Have any of you already done something like this?
Thank you, Alberto
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Good morning,
in my apartment I do not have the ability to pull other cables to match some equipment.
The only connection I have between the apartment and the control point where I have raspberry with codesys is the network.
My aim is to send the status of a button to codesys and how many times it is pressed to run preset scenarios.
For example, press the button once, turn on all the lights, press twice, turn off all the lights, press the button for a long time, cancel the operation.
In large lines is what I would like to do
So I was thinking of installing an arduino and passing the states via modbus directly to codesys?
Is it possible for you to do this in this way?
Have any of you already done something like this?
Thank you, Alberto