Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I AM USING SERIAL MODBUS MODULES. THE CONTROL IS PERFORMED BY FLANK UP.
MY QUESTION IS IF THERE IS SOME SYSTEM VARIABLE THAT INDICATES THAT THE PORT IS FREE TO BE ABLE TO RE-APPLY THE FOLLOWING REQUEST and thus be able to optimize the process.
I found the one that tells me that all the slaves communicate, but that does not suit me.
best regardsΒ‘
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello,
I AM USING SERIAL MODBUS MODULES. THE CONTROL IS PERFORMED BY FLANK UP.
MY QUESTION IS IF THERE IS SOME SYSTEM VARIABLE THAT INDICATES THAT THE PORT IS FREE TO BE ABLE TO RE-APPLY THE FOLLOWING REQUEST and thus be able to optimize the process.
I found the one that tells me that all the slaves communicate, but that does not suit me.
best regardsΒ‘