Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I don't know how to use a MCP3008 to read in a analog value from a potentiometer using CODESYS ladder logic.
I think it's wired correctly but I'm not getting any output from it.
I also have no idea how to read an integer value on the raspberry pi 3 model B as each GPIO pin in CODESYS is set to a bit.
Any help would be appreciated.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi everyone,
I don't know how to use a MCP3008 to read in a analog value from a potentiometer using CODESYS ladder logic.
I think it's wired correctly but I'm not getting any output from it.
I also have no idea how to read an integer value on the raspberry pi 3 model B as each GPIO pin in CODESYS is set to a bit.
Any help would be appreciated.
Never mind. we got it working