CODESYS - the IEC 61131-3 automation software

Welcome to the official CODESYS Forum by 3S-Smart Software Solutions GmbH | A member of the CODESYS Group
Deutsche Version English version russian version 
It is currently Fri Dec 06, 2019 9:51 am

All times are UTC+01:00




Post new topic  Reply to topic  [ 1 post ] 
Author Message
PostPosted: Wed Mar 22, 2017 8:37 am 
Offline

Joined: Tue Mar 14, 2017 2:00 pm
Posts: 2
Hello, I would like to set up a 1734-OE2V card as a generic component
and connect it to a Raspberry via a 1734-AENTR coupler.

I understood what I had to put in "config"
but I did not figure out how much byte of input and output I had to assign to it ..

For an IB8 it takes 1 input byte.
For an OB8 this takes 1 input bytes and 1 output byte.
With these two cards I'm ok.

If any one could explain, I would be very grateful.

thank you !

Thomas.B


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 1 post ] 

All times are UTC+01:00


Who is online

Users browsing this forum: No registered users and 6 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited