Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
we've been playing a lot with the Raspberry Pi lately.
We already got most of our Ethernet I/P devices connected.
However, in order to use the RPi as fully functional PLC, we require 24V power I/O.
When importing to CODESYS, it is stated that codesys doesn't support modular EDS files.
Setting up a normal ENIP Adapter wasnt successful so far (wrong byte numbers probably).
The RIO consists of a ENIP Adapter/Base with two 16DI and one 16DO.
Any ideas?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello together,
we've been playing a lot with the Raspberry Pi lately.
We already got most of our Ethernet I/P devices connected.
However, in order to use the RPi as fully functional PLC, we require 24V power I/O.
Since we use AB components mostly, we would like to communicate with a AB RIO.
EDS files can be found here: http://www.ab.com/networks/eds/cgi-bin/search.cgi
When importing to CODESYS, it is stated that codesys doesn't support modular EDS files.
Setting up a normal ENIP Adapter wasnt successful so far (wrong byte numbers probably).
The RIO consists of a ENIP Adapter/Base with two 16DI and one 16DO.
Any ideas?