Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I would want to connect my raspberry pi 3 with an schneider PLC TSX by modbusTCP.
But I don't understand if i need to use TCP slave or Master on Codesys V3.
Have you a project example of this configuration, please?
thks
Best regards
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello,
I would want to connect my raspberry pi 3 with an schneider PLC TSX by modbusTCP.
But I don't understand if i need to use TCP slave or Master on Codesys V3.
Have you a project example of this configuration, please?
thks
Best regards