CODESYS Forge - CODESYS Forge / Talk / Runtime 🇬🇧: CNC+Robotics SL on the Raspberry Pi

Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

CNC+Robotics SL on the Raspberry Pi

Forum: Runtime 🇬🇧

Creator: rotemse

Created: 2016-09-13

Updated: 2016-09-13

rotemse - 2016-09-13

Hi,
Is it possible to purchase and install the CNC+Robotics SL on the Raspberry Pi?

Thanks

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

eschwellinger - 2016-09-13

Hi,
This is not needed this is included in the Pi licence, just use it!
BR
Edwin

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Log in to post a comment.