CODESYS - the IEC 61131-3 automation software

Welcome to the official CODESYS Forum by 3S-Smart Software Solutions GmbH | A member of the CODESYS Group
Deutsche Version English version russian version 
It is currently Wed Oct 16, 2019 11:26 am

All times are UTC+01:00




Post new topic  Reply to topic  [ 1 post ] 
Author Message
PostPosted: Fri Aug 19, 2016 4:32 pm 
Offline

Joined: Tue May 12, 2015 8:40 am
Posts: 2
Is it possible to set a "Value" entry on the "GPIO Parameters" tab to a fixed value?
I would for instance like to use GPIO4 only as an input and never as an output.
I can set the default value, and limit the possibilities of the Value field to "Input" but I still have to
set the (only possible) value in the configuration.

Is it possible to skip or inhibit bit field entries on the "GPIOs I/O Mapping" tab?
Since GPIO 0 till 3 can not be used, it's useless to be able to assign a variable to it.
So I would like to inhibit those fields somehow (only when using BIT entries, not if the
bit is part of e.g. a Word, then the programmer is responsible to handle the bits properly).

Regards,

Ruud


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 1 post ] 

All times are UTC+01:00


Who is online

Users browsing this forum: No registered users and 5 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited